 |
| I found that two of my rear control plungers did not make contact with the camera controls easily. I had to push them in fairly hard. An easy way to boost any of the plungers is to use a #10 plastic screw cover from Lowe's Hardware and cut it down to size so it does not interfere with the movement of the plunger shaft. |
|
|
|
|
| Simply wedge it over the existing black plunger tip as shown on the photo below. Test it with the camera installed to be certain it is not continuously holding that specific camera control in the down position. |
|
|
|
|
|
|
|
|
|
