| This is a homemade tray
made from a single piece of 1" wide X 1/18" thick
aluminum. A 4' length is more than enough to do the job. The aluminum
was bent in a vice then joined at the ends where the strobe base is
mounted. This tray supports two GBUndersea lens docks, one for a wide
angle lens and one for a close-up lens. It also supports an Inon D-180
strobe on a loc-line arm. The handles were made from heater hose and
forced over the aluminum as it was bent. The black pipes are ABS plastic
and are used for buoyancy. This rig is slightly positively buoyant. The
length of the pipes determines the buoyancy relative to the total weight
of the rig |
